Removal and replacement procedures 68
b.
Remove the mounting screw from the slot (2).
Use this screw to install the SAS controller board.
3. Install the SAS controller board.
a. Slide the controller board into the slot (1).
Make sure the board is properly seated in the slot.
b. Secure the controller board with the one screw (2).
4. Place the PCI cage on the chassis but do not secure it yet.
You still need to access the system board connector (CN11) for the SAS LED cable located on
the front end of the PCI cage.
5. If you will be using a SAS cache battery, proceed to the next section for instructions on how to
install the SAS cache battery. If not, proceed to the “To connect the SAS HDD and LED cables”
section on page 70 to connect the SAS HDD and LED cables.
To Next Page
Loading...
