Removal and replacement procedures 76
3. Remove the defective system fan:
a. Disconnect the fan cable from its system board connector (1).
b. Remove the fan from its cage to release the fan cable (2).
c. Release the fan cable from the fan cage to completely remove the fan from the chassis (3).
4. Remove the new system fan from its protective packaging.
5. Install the new system fan.
a. Route the fan cable through the vacated fan bracket (1).
b. Insert the fan in the fan bracket (2).
c. Connect the fan cable to its corresponding board connector (4).
6. Perform the post-installation procedure.
To Next Page
Loading...
