Removal and replacement procedures 26
3.
Remove the air baffle.
To replace the component, reverse the removal procedure.
PCIe riser cage
CAUTION: To prevent damage to the server or expansion boards, power down the server and
remove all AC power cords before removing or installing the PCIe riser board assembly.
To remove the component:
1. Power down the server (on page 24).
2. Remove the server from the rack (on page 24).
3. Remove the access panel ("Access panel" on page 25).
4. Disconnect all internal cables connected to existing expansion boards.
5. Remove the PCIe riser cage:
a. Remove the T-10 screw.
b. Remove the T-15 screws.
To Next Page
Loading...
