Removal and replacement procedures 28
o
Low-profile riser board
To replace the component, reverse the removal procedure.
Drive blank
CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless
all bays are populated with either a component or a blank.
Remove the component as indicated.
To replace the component, reverse the removal procedure.
Hot-plug drive
IMPORTANT: Hot-plug capability and drive LED support are only available when a supported
optional controller is installed in the server.
To remove the component:
1. Back up all data on the drive.
2. Power down the server (on page 24).
To Next Page
Loading...
