Removal and replacement procedures 29
CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless
all bays are populated with either a component or a blank.
3. Remove the drive.
WARNING: To reduce the risk of injury from electric shock, do not remove more than one drive
carrier at a time.
To replace the component, reverse the removal procedure.
Redundant hot-plug power supply
WARNING: To reduce the risk of personal injury from hot surfaces, allow the power supply or
power supply blank to cool before touching it.
CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless
all bays are populated with either a component or a blank.
To remove the component:
1. Determine how many hot-plug power supplies are installed:
o If only one hot-plug power supply is installed, power down the server (on page 24).
o If more than one hot-plug power supply is installed, continue with the next step.
2. Disconnect the power cord from the source.
3. Remove the power cord from the power supply.
To Next Page
Loading...
