Removal and replacement procedures 30
4.
Remove the power supply from the server.
WARNING: To reduce the risk of electric shock or damage to the equipment, do not connect the
power cord to the power supply until the power supply is installed.
To replace the component, reverse the removal procedure.
Redundant hot-plug power supply backplane
WARNING: To reduce the risk of personal injury from hot surfaces, allow the power supply or
power supply blank to cool before touching it.
CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless
all bays are populated with either a component or a blank.
To remove the component:
1. Power down the server (on page 24).
2. Remove the redundant hot-plug power supplies ("Redundant hot-plug power supply" on page 29).
3. Remove the server from the rack (on page 24).
4. Remove the access panel ("Access panel" on page 25).
5. Remove the air baffle ("Air baffle" on page 25).
6. Disconnect the power supply cables.
For more information, see "Redundant power supply cabling (on page 56)".
7. Remove the system board ("System board" on page 48).
To Next Page
Loading...
