HP ProLiant DL120 G7 - Page 47

Removal and replacement procedures 47
5.
Install the heatsink, and then insert and tighten the two screws.
6. Install the air baffle.
7. Install the access panel.
8. Install the server into the rack.
9. Power on the server.
DIMM
To remove the component:
1. Power down the server (on page 24).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
o Extend the server from the rack.
o Remove the server from the rack (on page 24).
4. Remove the access panel ("Access panel" on page 25).
5. Remove the air baffle ("Air baffle" on page 25).
6. Open the DIMM slot latches.