HP ProLiant DL120 G7 - Cabling; Cabling Overview and Server Cabling Practices; Power and Internal Cabling

Removal and replacement procedures 48
7.
Remove the DIMM.
To replace the component, reverse the removal procedure.
System board
To remove the component:
1. Power down the server (on page 24).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Remove the server from the rack (on page 24).
4. Remove the access panel ("Access panel" on page 25).
5. Remove the air baffle ("Air baffle" on page 25).
6. Remove the PCIe riser cage ("PCIe riser cage" on page 26).
7. Remove the battery pack ("BBWC battery pack" on page 38).
8. Remove all DIMMs ("DIMM" on page 47).
9. Disconnect all cables connected to the system board.