Removal and replacement procedures 35
4.
Remove the fan module.
To replace the component:
1. Install the fan module.
2. Install the access panel ("Access panel" on page 27).
3. Slide the server into the rack.
4. Power up the server.
Fan blank
Install fan 2 only when processor 2 is installed. When only one processor is installed, always install the
fan blank.
To remove the component:
1. Power down the server (on page 24).
2. Extend the server from the rack (on page 25).
3. Remove the access panel ("Access panel" on page 27).
To Next Page
Loading...
