Removal and replacement procedures 38
c.
Lift the assembly to unseat the PCI riser boards, and then remove the assembly.
7. Remove all expansion boards ("Expansion boards" on page 38).
To replace the component, reverse the removal procedure.
Expansion boards
To remove the component:
1. Power down the server (on page 24).
2. Extend the server from the rack (on page 25).
3. Remove the access panel ("Access panel" on page 27).
4. Remove the BBWC battery pack, if installed ("BBWC battery pack" on page 36).
5. Remove the air baffle ("Air baffle" on page 37).
6. Remove the PCI riser board assembly ("PCI riser board assembly" on page 37).
7. Remove the expansion board.
To replace the component, reverse the removal procedure.
To Next Page
Loading...
