HP ProLiant DL360 G6 - Memory Options

Removal and replacement procedures 39
PCIe riser board
To remove the component:
1. Power down the server (on page 24).
2. Extend the server from the rack (on page 25).
3. Remove the access panel ("Access panel" on page 27).
4. Remove the BBWC battery pack, if installed ("BBWC battery pack" on page 36).
5. Remove the air baffle ("Air baffle" on page 37).
6. Remove the PCI riser board assembly ("PCI riser board assembly" on page 37).
7. Remove all expansion boards ("Expansion boards" on page 38).
8. Remove the full-length PCIe riser board from the riser board assembly.
To replace the component, reverse the removal procedure.
PCI-X riser board
To remove the component:
1. Power down the server (on page 24).
2. Extend the server from the rack (on page 25).
3. Remove the access panel ("Access panel" on page 27).
4. Remove the BBWC battery pack, if installed ("BBWC battery pack" on page 36).
5. Remove the air baffle ("Air baffle" on page 37).
6. Remove the PCI riser board assembly ("PCI riser board assembly" on page 37).
7. Remove all expansion boards ("Expansion boards" on page 38).