Removal and replacement procedures 56
5.
Close the processor retaining latch and the processor socket retaining bracket.
6. Clean the old thermal grease from the heatsink and the top of the processor with the alcohol swab.
Allow the alcohol to evaporate before continuing.
7. Apply all the grease to the top of the processor in one of the following patterns to ensure even
distribution.
8. Install the heatsink ("Heatsink" on page 45).
IMPORTANT: To ensure proper cooling, be sure the processor air baffle is installed at all
times (if applicable).
9. Install all components removed from the failed system board.
IMPORTANT: Install all components with the same configuration that was used on the failed
system board.
10. Install the hard drives ("SAS and SATA hard drive" on page 30).
11. Install all power supplies ("Hot-plug power supply" on page 31).
To Next Page
Loading...
