Removal and replacement procedures 20
5.
Remove the hot-plug power supply.
WARNING: To reduce the risk of electric shock or damage to the equipment, do not connect
the power cord to the power supply until the power supply is installed.
To replace the component:
1. Slide the hot-plug power supply into the power supply bay.
2. Connect the power cord to the power supply.
3. Install the cable management arm, if removed.
4. Route the power cord through the cable management arm or power cord anchor.
NOTE: If using the power cord anchor, be sure to leave enough slack in the power cord so
that the redundant power supply can be removed without disconnecting the power cord from
the primary power supply.
5. Close the cable management arm.
6. Connect the power cord to the power source.
7. Be sure that the power supply LED is green ("Rear panel LEDs and buttons" on page 56).
8. Be sure that the power supply LED on the SID is green.
Hard drive cage
To remove the component:
1. Power down the server (on page 13).
2. Extend the server from the rack (on page 14).
3. Remove all hard drives ("SAS and SATA hard drive" on page 18).
To Next Page
Loading...
