HP ProLiant DL360 G7 - Access Panel Procedures; BBWC;FBWC Pack Removal

Removal and replacement procedures 21
4.
Remove the hard drive cage.
To replace the component, reverse the removal procedure.
DVD tray
To remove the component:
1. Power down the server (on page 13).
2. Extend the server from the rack (on page 14).
3. Remove the access panel ("Access panel" on page 16).
4. If installed, remove the BBWC battery pack or the FBWC capacitor pack ("BBWC battery pack or
FBWC capacitor pack" on page 25).
5. Remove the air baffle ("Air baffle" on page 26).
6. Disconnect the SATA DVD cable from the rear of the DVD tray ("DVD-ROM and DVD-RW drive
cabling" on page 48).