Diagnostics and Troubleshooting
4-58 Compaq ProLiant DL360 Server Maintenance and Service Guide
COMPAQ CONFIDENTIAL Codename: MIcroMachines Part Number: 169616-006 Last Saved On: 12/21/01 9:05 AM
Table 4-18: ASR-2 Features
Features Definition
Software error recovery If enabled, ASR-2 is activated if the OS hangs or has a
crash that results in a lockup.
Software error recovery timeout Determines how long the server waits to enable ASR-2
after an OS lockup.
Standby recovery server option If enabled, ASR-2 activation initiates a switch to a
standby recovery server.
Standby recovery server port Port used to communicate with the recovery server.
Standby recovery timeout Determines how long the server waits to initiate switch
after ASR-2 activation.
Software error recovery start option Allows the server to restart either into the OS or into
Compaq Utilities.
Thermal shutdown If enabled, shuts down the server if a critical thermal
error occurs.
UPS shutdown If enabled, allows the server to perform a shutdown if a
UPS is activated.
UPS shutdown threshold Determines how long the server waits to shut down
after the UPS is activated. If desired, this number
should provide enough time for an administrator to
perform any necessary operations or to gracefully shut
down the server.
Compaq Integrated Remote Console
The standard Compaq Integrated Remote Console performs a wide range of configuration
activities. Console features include:
• Is accessible using ANSI terminal
• Operates independently of the operating system
• Provides for remote server restart
• Provides access to system configuration
• Uses out-of-band communication with dedicated management modem installed in the
server
For more information, see the Integrated Remote Console User Guide that shipped with the
server.
IMPORTANT: Before configuring ASR-2, verify that the System Configuration Utility and Diagnostics
software are installed on the Compaq system partition. ASR-2 must have this to start Compaq Utilities
after a system restart. Compaq recommends this even if you configure ASR-2 to start the operating
system.
To Next Page
Loading...
