Connectors, Switches, and Status Indicators
Compaq ProLiant DL360 Server Maintenance and Service Guide 5-5
COMPAQ CONFIDENTIAL Codename: MicroMachines Part Number: 169616-006 Last Saved On: 1/7/02 10:57 AM
System Board Switches
The Compaq ProLiant DL360 server has two switch banks (1 and 2) located on the system
board that are used to set the overall configuration of your server.
• The system identification switch (SW1)
is an eight-position switch (S1-S8) that
provides the processor switch settings of your server.
The server autodetects and configures these switch settings.
CAUTION: Do not change these settings. The system automatically detects and configures
settings when a processor is added or replaced.
• The system configuration switch 2 (SW2)
is a six-position switch (S1-S6) that is used
for maintenance configuration.
Refer to the labels on the inside of the system unit cover or to the following table for the
proper system configuration switch settings. The following figure shows the location of the
system switches.
2
1
Figure 5-4: System board switches
To Next Page
Loading...
