Removal and Replacement Procedures
Compaq ProLiant DL360 Server Maintenance and Service Guide 2-25
COMPAQ CONFIDENTIAL Codename: MicroMachine Part Number: 169616-006 Last Saved On: 12/31/01 11:05 AM
Internal Smart Array/SCSI Controller Interface Assembly
To remove an optional Smart Array/SCSI controller interface assembly:
1. Complete the preparation procedures. See “Powering Down the Server” earlier in this
chapter.
2. Remove the access panel. See “Server Access Panel” earlier in this chapter.
3. Disconnect the optional Smart Array/SCSI controller interface assembly cable from the
expansion board
.
CAUTION:
lways disconnect the Smart Array/SCSI controller interface assembly cable from
the expansion board before removing the PCI riser board assembly. Failure to disconnect the
cable may result in damage to the expansion board and the cable.
4. Remove the PCI riser board assembly. See “PCI Riser Board Assembly” earlier in this
chapter.
5. Disconnect the optional Smart Array/SCSI controller interface assembly from the system
board
.
6. Lift the locking tab on the interface assembly
.
7. Slide the assembly toward the rear of the server, unlocking it from the chassis, and lift to
remove
.
2
3
4
1
Figure 2-20: Removing the optional internal array
controller interface assembly
Reverse steps 1 through 7 to replace the optional Smart Array/SCSI controller interface
assembly.
To Next Page
Loading...
