Removal and Replacement Procedures
2-42 Compaq ProLiant DL360 Server Maintenance and Service Guide
COMPAQ CONFIDENTIAL Codename: MicroMachine Part Number: 169616-006 Last Saved On: 12/31/01 11:05 AM
WARNING: To reduce the risk of personal injury from hot surfaces, allow the internal
system components to cool before touching.
To remove the Integrated Smart Array Controller:
1. Complete the preparation procedures. See “Powering Down the Server” earlier in this
chapter.
2. Remove the server access panel. See “Server Access Panel” earlier in this chapter.
3. Pull the latches outward
.
4. When the Integrated Smart Array Controller rises to a 45-degree angle, pull the controller
out of the slot
.
1
2
1
Figure 2-36: Removing the Integrated Smart Array
Controller from the system board
Reverse steps 1 through 4 to replace the Integrated Smart Array Controller.
To Next Page
Loading...
