HP ProLiant DL360p Quickspecs

NOTE:
NOTE:NOTE:
NOTE: This section lists some of the steps required to configure a Factory Integrated Model. To ensure only valid configurations are
ordered, HP recommends the use of an HP approved configurator. Contact your local sales representative for information on
configurable product offerings and requirements.
NOTE:
NOTE:NOTE:
NOTE: Configure-to-order (CTO) servers must start with a CTO Chassis.
NOTE:
NOTE:NOTE:
NOTE: FIO indicates that this option is only available as a factory installable option.
Step 1: Base Configuration (choose one of the following configurable models)
Step 1: Base Configuration (choose one of the following configurable models)Step 1: Base Configuration (choose one of the following configurable models)
Step 1: Base Configuration (choose one of the following configurable models)
HP Models
HP ModelsHP Models
HP Models HP ProLiant DL360p Gen8 8 SFF Configure-to-order Server 654081-B21
Factory Integrated Model ships with:
Factory Integrated Model ships with:Factory Integrated Model ships with:
Factory Integrated Model ships with:
2 x HP Smart Socket Guides for fast processor installation
Drive Cage - 8-Small Form Factor
24 DIMM slots for RDIMM, LRDIMM and UDIMM SmartMemory installation
(1) FlexibleLOM connection point: (see Step2: HP FlexibleLOM NIC section below for
NIC choices to populate the embedded connector)
Smart Array P420i Controller (Cache connection for 512MB, 1GB and 2GB FBWC
options)
I/O slots - 2 Slots come standard:
Slot 1 - Full-Height/Half-Length x 16 PCIe 3.0
Slot 2 - Low Profile x 8 PCIe 3.0
System Fans - 6 (2 additional fans included with second processor)
USB - 4 Rear, 2 Front, 1 Internal
1 Internal SD slot
On System Server Management Processor - HP iLO 4 (embedded)
SID - System Insight Display(Active Health Indicator)
Power Supply not included - choose from Power Options section
NOTE:
NOTE: NOTE:
NOTE: With new options available for Networking solutions and Rack Rail Kits these
options are no longer standard on-board with this Model Part Number. Please see the
Networking and HP Rack Options below for optional required options.
HP ProLiant DL360p Gen8 4 LFF Configure-to-order Server 655651-B21
Factory Integrated Model ships with:
Factory Integrated Model ships with:Factory Integrated Model ships with:
Factory Integrated Model ships with:
2 x HP Smart Socket Guides for fast processor installation
Drive Cage - 4-Large Form Factor
24 DIMM slots for RDIMM, LRDIMM and UDIMM SmartMemory installation
(1) FlexibleLOM connection point: (see Step2: HP FlexibleLOM NIC section below for
NIC choices to populate the embedded connector)
Smart Array P420i Controller (Cache connection for 512MB, 1GB and 2GB FBWC
options)
I/O slots - 2 Slots come standard:
Slot 1 - Full-Height/Half-Length x 16 PCIe 3.0
Slot 2 - Low Profile x 8 PCIe 3.0
System Fans - 6 (2 additional fans included with second processor)
USB - 4 Rear, 2 Front, 1 Internal
1 Internal SD slot
On System Server Management - (HP iLO Management Engine) (embedded)
SID - System Insight Display(Active Health Indicator)
QuickSpecs
HP ProLiant DL360p Generation 8 (Gen8)
HP ProLiant DL360p Generation 8 (Gen8)HP ProLiant DL360p Generation 8 (Gen8)
HP ProLiant DL360p Generation 8 (Gen8)
Configuration Information - Factory Integrated Models
DA - 14211 North America — Version 5 — April 19, 2012 Page 22

HP ProLiant DL360p Specifications

General

Max Processors	2
Form Factor	1U Rack
Memory	Up to 768GB DDR3
Memory Slots	24
RAID Support	HP Smart Array P420i Controller
Network	4 x 1Gb Ethernet ports
Power Supply	460W, 750W
Management	HP iLO (Integrated Lights-Out)
Storage	8 SFF or 4 LFF