HP ProLiant DL380 G6 - Page 61

Removal and replacement procedures 61
8.
Close and lock the heatsink retaining latches.
9. Install the air baffle ("Air baffle" on page 41).
10. If the PCI riser cage was removed, install the PCI riser cage.
11. Install the access panel ("Access panel" on page 29).
12. Install the server into the rack.
13. Power up the server.
DIMMs
IMPORTANT: This server does not support mixing RDIMMs and UDIMMs. Attempting to mix
these two types causes the server to halt during BIOS initialization.
To identify the DIMMs installed in the server, see "DIMM identification (on page 86)."
To remove the component:
1. Power down the server (on page 24).
2. Extend or remove the server from the rack ("Remove the server from the rack" on page 25, "Extend the
server from the rack" on page 25).
3. Remove the access panel ("Access panel" on page 29).
4. Remove the PCI riser cage ("PCI riser cage" on page 40).
5. Remove the air baffle ("Air baffle" on page 41).