Removal and Replacement Procedures 31
4. Remove the PCI riser cage door latch.
Expansion Board (Slots 2 and 3)
IMPORTANT: Be sure that the proper drivers for PCI Hot Plug
functionality are installed. Refer to the Documentation CD for more
information.
To remove the component:
CAUTION: If the operating system installed on the server
does not support PCI Hot Plug functionality, power down the server
before removing expansion boards.
1. Extend or remove the server from the rack ("Extending the Server from the
Rack" on page 16
, "Removing the Server from the Rack" on page 18).
2. Remove the access panel ("Removing the Access Panel" on page 19
).
HP CONFIDENTIAL
File Name: 291916-6.doc Last Saved On: 2/5/04 2:26 PM
To Next Page
Loading...
