Removal and Replacement Procedures 45
To replace the component, reverse the removal procedure.
Expansion Board (Slot 1)
To remove the component:
1. Power down the server.
2. Extend or remove the server from the rack ("Extending the Server from the
Rack" on page 16
, "Removing the Server from the Rack" on page 18).
3. Remove the access panel ("Removing the Access Panel" on page 19
).
4. Remove the PCI riser cage ("PCI Riser Cage" on page 44
).
CAUTION: To prevent damage to the server or expansion
boards, power down the server and remove all AC power cords before
removing or installing the PCI riser cage.
5. Disconnect any cables connecting the expansion board to the PCI riser cage.
HP CONFIDENTIAL
File Name: 291916-6.doc Last Saved On: 2/5/04 2:26 PM
To Next Page
Loading...
