Hardware options installation 47
5.
Remove the air baffle (on page 24).
6. Remove the PCI riser cages (on page 25).
7. Connect the two-port SATA cable:
a. Connect the cable to the drive sideband signal connector.
b. Secure the cable in the cable clip.
c. Connect the cable to the SATA storage and optical drive connectors.
d. Route the cable along the side of the system board towards the front chassis, and then connect the
cable to the drive backplane.
o LFF drive
o SFF drive
8. Connect the rest of the drive cables required in this drive configuration. For more information, see
"Storage cabling (on page 85)."
9. Install the PCI riser cages (on page 26).
10. Install the air baffle (on page 24).
11. Install the access panel (on page 23).
To Next Page
Loading...
