HP ProLiant DL380e - Page 37

Removal and replacement procedures 37
6.
Remove the optical drive.
To replace the component, reverse the removal procedure.
Optical drive cage
To remove the component:
1. Power down the server (on page 29).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
o Extend the server from the rack (on page 30).
o Remove the server from the rack (on page 32).
4. Remove the access panel ("Access panel" on page 35).
5. Remove the optical drive ("Optical drive" on page 36).