Removal and replacement procedures 58
CAUTION: For proper cooling, do not operate the server without the access panel, baffles,
expansion slot covers, or blanks installed. If the server supports hot-plug components, minimize
the amount of time the access panel is open.
To remove the component:
1. Power down the server (on page 29).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
o Extend the server from the rack (on page 30).
o Remove the server from the rack (on page 32).
4. Remove the access panel ("Access panel" on page 35).
5. Remove the PCI riser cage ("PCI riser cage" on page 53).
6. Remove the expansion slot blank:
a. Open the expansion slot cover retainer.
b. Remove the expansion slot blank.
— Primary PCI riser cage
To Next Page
Loading...
