Removal and replacement procedures 66
o
Remove the server from the rack (on page 32).
4. Remove the access panel ("Access panel" on page 35).
5. Remove the capacitor pack.
6. Remove the capacitor pack holder.
To replace the component, reverse the removal procedure.
Recovering data from the flash-backed write cache
If the server fails, use the following procedure to recover data temporarily stored in the FBWC.
CAUTION: Before starting this procedure, read the information about protecting against
electrostatic discharge ("Preventing electrostatic discharge" on page 26).
1. Perform one of the following:
To Next Page
Loading...
