• DIMMs must be installed in decreasing capacity with the largest DIMMs installed in the banks
farthest away from each processor.
• DIMM pairs in a memory bank must have identical HP DIMM part numbers.
• Only HP DIMM part numbers listed in the QuickSpecs for this server should be used in this server.
DIMM population order
Bank A Bank B Bank C Bank D Bank E Bank F Bank G Bank H
Configuration 1A & 2A 3B & 4B 5C & 6C 7D & 8D 9E & 10E 11F & 12F 13G & 14G 15H & 16H
1 processor 1st 2nd 3rd 4th — — — —
2 processors 1st 2nd 3rd 4th 1st 2nd 3rd 4th
Advanced ECC memory is the memory protection mode for this server. In Advanced ECC, the server does
not fail because of correctable memory errors. The server provides notification if the level of correctable
errors exceeds a pre-defined threshold rate. Advanced ECC provides additional protection over standard
ECC because it is possible to correct certain memory errors that would otherwise be uncorrectable and
result in a server failure. Whereas standard ECC can correct single-bit memory errors, Advanced ECC
can correct single-bit memory errors and multi-bit memory errors if all failed bits are on the same DRAM
device on the DIMM.
Removal and replacement procedures 55
To Next Page
Loading...
