5.
Close the processor retaining latch and the processor socket retaining bracket.
6. Clean the old thermal grease from the heatsink and the top of the processor with the alcohol swab.
Allow the alcohol to evaporate before continuing.
7. Apply all the grease to the top of the processor in one of the following patterns to ensure even
distribution:
8. Install the heatsink ("Heatsink" on page 46).
9. Install all components removed from the failed system board.
10. Install the access panel ("Access panel" on page 30).
11. Install the power supplies ("Hot-plug power supply" on page 28).
12. Power up the server.
IMPORTANT: Install all components with the same configuration that was used on the failed
system board.
After you replace the system board, you must re-enter the server serial number and the product ID.
Removal and replacement procedures 61
To Next Page
Loading...
