Removal and replacement procedures 32
3.
Lower the processor module lever, and pull the module out of the server.
4. Release the latch, and open the cover to expose the processors.
To replace the component, reverse the removal procedure.
Removing a processor or processor blank
CAUTION: To prevent thermal instability and damage to the server, do not separate the processor from the
heatsink. The processor, heatsink, and retaining clip make up a single assembly.
CAUTION: To prevent possible server malfunction and damage to the equipment, do not mix single- and
dual-core processors or processors with different speeds or cache sizes.
CAUTION: To prevent thermal damage, do not operate a server with dual-core processors installed unless
all processor sockets have either a processor or processor blank installed.
To remove a processor or processor blank:
1. Power down the server (on page 27).
2. Remove the processor module ("Removing the processor module" on page 31).
To Next Page
Loading...
