Removal and replacement procedures 46
10.
Press the F10 key to confirm exiting RBSU. The server will automatically reboot.
Battery
If the server no longer automatically displays the correct date and time, you may need to replace the
battery that provides power to the real-time clock. Under normal use, battery life is 5 to 10 years.
WARNING: The computer contains an internal lithium manganese dioxide, a vanadium
pentoxide, or an alkaline battery pack. A risk of fire and burns exists if the battery pack
is not properly handled. To reduce the risk of personal injury:
• Do not attempt to recharge the battery.
• Do not expose the battery to temperatures higher than 60°C (140°F).
• Do not disassemble, crush, puncture, short external contacts, or dispose of in fire or
water.
• Replace only with the spare designated for this product.
To remove the component:
1. Power down the server (on page 27).
2. Extend the server from the rack, if applicable ("Extending the server from the rack" on page 26).
3. Remove the access panel ("Removing the access panel" on page 28).
4. Remove any hardware that will interfere with accessing the battery.
5. Remove the battery.
To replace the component, reverse the removal procedure.
For more information about battery replacement or proper disposal, contact an authorized reseller or an
authorized service provider.
Removing the media board
1. Power down the server (on page 27).
2. Extend the server from the rack, if applicable ("Extending the server from the rack" on page 26).
3. Remove the access panel ("Removing the access panel" on page 28).
To Next Page
Loading...
