Removal and replacement procedures 48
14.
Pull the media pass-through board out of the server.
To replace the component, reverse the removal procedure.
Removing the SAS backplane
1. Power down the server (on page 27).
2. Extend or remove the server from the rack ("Extending the server from the rack" on page 26,
"Remove the server from the rack" on page 27).
3. Remove the access panel ("Removing the access panel" on page 28).
4. Remove all hard drives ("Removing a hot-plug SAS hard drive" on page 51) and hard drive blanks
("Removing a hard drive blank" on page 51).
5. Remove all media drives and media drive blanks ("Removing a diskette, DVD, CD-RW drive or
blank" on page 30).
6. Remove the screws securing the SAS hard drive cage.
To Next Page
Loading...
