Removal and replacement procedures 50
6.
Loosen the thumbscrew, and remove the power backplane from the server.
To replace the component, reverse the removal procedure.
Removing the memory backplane
1. Power down the server (on page 27).
2. Remove all memory boards ("Removing a memory board" on page 62, "Removing a memory board
(non-hot-plug)" on page 61).
3. Remove the processor module ("Removing the processor module" on page 31).
4. Extend or remove the server from the rack ("Extending the server from the rack" on page 26,
"Remove the server from the rack" on page 27).
5. Remove the access panel ("Removing the access panel" on page 28).
6. Open the latch, and lift the memory backplane from the server.
To replace the component, reverse the removal procedure.
To Next Page
Loading...
