20
Drive latch
You can remove the latch that secures and allows removal of the drives.
To replace the drive latch:
1. Perform steps 1 through 3 of the Pre-installation instructions.
2. Remove the access panel.
3. Remove the front bezel.
4. Remove the drive latch:
a. Pull the latch to loosen the two tabs that secure the latch to the chassis.
b. Slide the latch straight down and remove it from the chassis.
NOTE: To loosen the latch, you may also have to pull the tabs that secure inserted drives. Drive latch
tabs may break during removal.
Figure -18 [Removing the drive latch]
5. Install a new drive latch:
a. Insert the two tabs on the top of the latch into their holders near the top of the chassis.
b. Slide the latch upward until the two tabs in the middle of the latch click into place.
Figure -19 [Installing a drive latch]
6. Observe the post-installation procedures.
To Next Page
Loading...
