23
Figure -23 [Installing a processor]
After you install the processor, you must reinstall the HSF on top of the processor socket. The thermal grease you
applied on the contact surfaces of the HSF and the processor provides the necessary thermal bonding to allow
the heatsink to draw heat from the processor.
CAUTION: To prevent processor overheating or system instability, use only an HSF assembly specified for the
HP ProLiant ML110 Generation 3 server.
10. Replace the heatsink-cooling fan assembly:
a. Properly align the HSF mounting pins to the system board mounting holes and press down until you
hear a click.
b. Twist the mounting pins clockwise to secure the HSF connection to the system board.
c. Connect the processor fan cable to the connector on the system board (P70).
CAUTION: Failure to connect the processor fan cable to the system board may result in damage to the
processor and could cause the server to shut down without displaying messages.
Figure -24 [Installing the heatsink-cooling fan assembly]
11. Observe the post-installation procedures.
To Next Page
Loading...
