31
HP Lights-Out 100 Remote Management Card
Lights-Out 100 Remote Management is a suite of products that enable remote management of ProLiant 100
Series servers. HP Lights-Out 100 allows customers or their service providers to remotely manage ProLiant ML110
G3 servers over a LAN or the Internet. With HP Lights-Out 100, users can access a system's text console, control
system power, and monitor system environmental conditions from a browser or command line.
To install the remote management card:
1. Perform steps 1 through 3 of the Pre-installation instructions.
2. Remove the access panel.
3. Lay the server on its side with the open side facing up.
4. Locate the remote management card connector on the system board.
Figure -38 [Remote management card connector location]
5. Install the remote management card in the connectors located in J110 and J111 on the system board. The
connectors are angled so that you can only install the card in one at the correct position.
Figure -39 [Installing the remote management card]
6. Observe the post-installation procedures.
To Next Page
Loading...
