35
Table -2 Setup Utility Primary Menus
Menu Function
Boot Use this menu to:
• Enable or disable the BIOS summary display.
• Enable or disable the HP splash display.
• Turn on or off bootup NumLock.
• Set restore on AC power loss options, such as last state, power off, and power on.
• Set boot device priority. By default, the server searches for boot devices in the following order:
a. Removable device
b. IDE CD-ROM drive
c. Hard disk drive
d. PXE (Preboot Execution Environment, remote boot)
• View hard disk drive information.
• View network drive information.
Security Use this menu to:
• Prevent unauthorized users from accessing the system.
• Configure user access levels.
• Input asset tag ID.
For more information about this menu, please refer to the System Passwords section in this chapter.
Exit Use this menu to select an exit option from the Setup Utility. Options include:
1 Save changes and exit out of the Setup Utility
2 Discard any changes made and exit out of the Setup Utility
3 Discard any changes made and remain in the Setup Utility
4 Load optimal default CMOS configuration for the system
System Summary Screen
Figure -3 [System Summary screen]
To enable display of the System Summary Screen during bootup:
1. From the Main menu screen, select Boot.
2. Select Boot Settings Configuration.
3. Select the BIOS Summary Display field.
4. Press the plus (+) or minus (-) key to set the field to Enabled.
To Next Page
Loading...
