37
Figure -5 [Enter New Password dialog box]
3. Retype the password to verify the first entry, and then press Enter.
4. Press F10 to save the password and close the Setup Utility.
After setting the password, Setup automatically sets the selected password field to Enabled.
To reset a system password:
• If you forget the user password or the supervisor password, the server functions normally, but you cannot
access the Setup Utility.
• If you do not know the user password but do know the supervisor password, you can use the Clear User
Password menu to clear the user password.
• If “Always” is selected in the Password check field and you do not know either the user or the supervisor
password, you cannot boot to the operating system or access the Setup Utility.
1. Perform the Pre-installation instructions listed in Chapter 2.
2. If necessary, remove any accessory boards or cables that prevent access to the CMOS button.
3. Locate the Password jumper (P137) on the system board.
4. Remove the jumper from pins 1 and 2 and power on the server.
5. Power down the server.
6. Place the jumper back on pins 1 and 2.
7. Reinstall the access panel as described in Chapter 2.
Loading system defaults
To load system default settings:
1. Reboot the server.
2. During POST, press F10 to access the Setup Utility.
3. Press F9 to load the default values.
4. Press F10 to save the changes and close the Setup Utility.
To Next Page
Loading...
