To Next Page

To Previous Page

System Configuration

c. Detach the bottom edge of the bezel from the front panel, after which

d. Pull the whole bezel away from the front panel.

Figure 4-3: Removing the front bezel

3. Place the front bezel in a safe place for reinstallation later.

To Reinstall the Front Bezel

1. Position the bezel so the two mounting tabs are aligned with their notch on the front

panel, then insert the tabs into their notch.

HP ProLiant ML110 Server Operations and Maintenance Guide 4-5

Other manuals for HP ProLiant ML110

Questions and Answers:

Need help?

Do you have a question about the HP ProLiant ML110 and is the answer not in the manual?

General

Product Line	ProLiant
Server Type	Tower
Processor	Intel Xeon E3-1200 series
Chipset	Intel C202
Memory Slots	4
Storage	SATA Hard Drives (HDDs) or Solid State Drives (SSDs)
Drive Bays	4 LFF or 8 SFF
RAID Support	RAID 0, 1, 10
Form Factor	Tower
Management	HP iLO
Operating System Support	Windows Server, Linux, VMware
Memory	DDR3 or DDR4 ECC Unbuffered DIMMs (UDIMMs) (depending on the specific generation)