BIOS Setup Utility
• User password
Entering this password will only allow the user to access and modify certain items in the
Setup Utility. These items include:
— Main menu: System Time and System Date
— Security menu: Set User password
• Power-on password
When the Password on Boot parameter in the Security
menu is enabled, either the
supervisor or the user password will be required to boot up the server.
To Set a System Password
NOTE: A Supervisor password should be set first before a User password can be defined.
1. In the Security menu screen, select a set password parameter—Set User Password or Set
Supervisor Password, then press Enter.
A password box will display.
Figure 5-3: Set Password box
2. Type a password.
The password may consist of up to eight alphanumeric characters (A-Z, a-z, 0-9).
3. Retype the password to verify the first entry, then press Enter.
4. If you want the new password to be check during bootup, select the Password on Boot
parameter on the Security
menu and set it to Enabled.
5. Press F10 to save the password and close the Setup Utility.
After setting the password, the system automatically changes the chosen password
parameter to Enabled.
To Change a System Password
1. In the Security menu screen, select a set password parameter—Set User Password or Set
Supervisor Password, then press Enter.
A password box will display.
2. Type the original password then press Enter.
3. Type a new password then press Enter.
5-6 HP ProLiant ML110 Server Operations and Maintenance Guide
To Next Page
Loading...
Need help?
General
