Removal and Replacement Procedures
System Power Down
WARNING: To reduce the risk of personal injury, electric shock, or damage to the
equipment, remove the power cord to remove power from the system. The front panel
Power On/Standby button does not completely shut off system power. Portions of the
power supply and some internal circuitry remain active until AC power is removed.
CAUTION: Failure to follow these directions could result in damage to equipment or loss of
data.
IMPORTANT: If installing a hot-plug device, it is not necessary to power down the system.
To power down the server:
1. Back up the server data and record configuration information.
2. Shut down the operating system as directed in the operating system instructions.
3. Press the Power On/Standby button to place the server in standby mode. When the server
acquires standby mode, the system power LED goes from green to amber.
4. After the system power LED is amber, disconnect the power cord.
5. Disconnect any other external equipment from the server.
2-4 HP ProLiant ML330 Generation 3 Server Maintenance and Service Guide
To Next Page
Loading...
Need help?
General
