Removal and replacement procedures 28
Remove the tower bezel
To replace the component, reverse the removal procedure.
Remove the rack bezel
To remove the component:
1. If installed, remove the security bezel (on page 29).
2. Power down the server (on page 27).
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Extend the server from the rack (on page 29).
5. Remove the access panel ("Access panel" on page 30).
6. Loosen the thumbscrews.
To Next Page
Loading...
