Removal and replacement procedures 40
To replace the component:
CAUTION: To prevent improper cooling and thermal damage, do not operate the server or the
enclosure unless all drive and device bays are populated with either a component or a blank.
1. Prepare the drive.
2. Install the drive.
3. Determine the status of the drive from the drive LED definitions (on page 89).
Non-hot-plug drive
CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless
all bays are populated with either a component or a blank.
To remove the component:
1. Do one of the following:
o For tower models, open and remove the bezel ("Remove the tower bezel" on page 28).
o For rack models, if installed, remove the security bezel (on page 29).
2. Power down the server (on page 27).
3. Remove all power:
To Next Page
Loading...
