Removal and replacement procedures 46
11.
Remove the screws, and then remove the power supply.
To replace the component, reverse the removal procedure.
Power supply module
To remove the component:
1. Do one of the following:
o For tower models, open and remove the bezel ("Remove the tower bezel" on page 28).
o For rack models, if installed, remove the security bezel (on page 29).
2. Power down the server (on page 27).
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Do one of the following:
o For tower models, place the server on a flat, level surface with the access panel facing up.
o For rack models, extend the server from the rack (on page 29).
To Next Page
Loading...
