M.2 solid-state drive
For a list of available solid-state drives, see Mass storage devices on page 9.
To remove the M.2 solid-state drive:
1. Prepare the computer for disassembly (see Preparing to disassemble the computer on page 19).
2. Remove the stand (see Stand on page 19).
3. Remove the rear port cover (see Rear port cover on page 24).
4. Remove the Phillips screw (1) that secures the drive to the computer.
5. Pull the drive away to remove it from the socket (2).
To install the solid-state drive, reverse the removal procedures.
M.2 solid-state drive 29
To Next Page
Loading...
