adjust the volume
51
hp psc 900 series
This selects the Advanced Fax Setup menu, then selects the Silent
Detect option.
3 Press to switch between Off and On.
4 After the state that you want appears, press Enter.
adjust the volume
Your HP PSC provides three levels for adjusting the ring and speaker
volume. The ring volume is the volume of the phone rings. The speaker
volume is the level of everything else, such as the dial and fax tones. The
default setting is soft.
1 Press Setup.
2 Press 3, then press 6.
This selects the Basic Fax Setup menu, then selects the Ring and
Beep Volume option.
3 Press to select one of the options: Soft, Loud, or Off.
4 Press Enter.
change the Answer Ring Pattern (distinctive ringing)
Distinctive ring feature that allows you to have several phone numbers on
the same line. Distinctive ring is usually offered by phone companies for an
additional fee, and may not be available in all regions. Each number has
a specific ring pattern. If you do not have this service, leave your HP PSC
set to use the default, All Rings.
If you connect your HP PSC to a line with distinctive ringing, have your
telephone company assign one ring pattern to voice calls and another to
fax calls (double or triple rings are best for a fax number).
1 Verify that your HP PSC is set to answer automatically.
2 Press Setup.
3 Press 4, then press 2.
This selects the Advanced Fax Setup menu, then selects the
Answer Ring Pattern option.
4 Press to scroll through these options: All Rings, Single Rings,
Double Rings, Triple Rings, and Double & Triple.
5 After the ring pattern that the phone company established for this
number appears, press Enter.
Tip! We recommend that you use Double Rings or Triple
Rings.
To Next Page
