9-17
Configuring and Monitoring Port Security
Web: Displaying and Configuring Port Security Features
The following command serves this purpose by removing 0c0090-123456 and
reducing the Address Limit to 1:
ProCurve(config)# port-security a1 address-limit 1
ProCurve(config)# no port-security a1 mac-address 0c0090-
123456
The above command sequence results in the following configuration for port
A1:
Web: Displaying and Configuring Port
Security Features
1. Click on the Security tab.
2. Click on [Port Security].
3. Select the settings you want and, if you are using the Static Learn Mode,
add or edit the Authorized Addresses field.
4. Implement your new data by clicking on [Apply Changes].
To access the web-based Help provided for the switch, click on
[?] in the web
browser screen.
Reading Intrusion Alerts and Resetting
Alert Flags
Notice of Security Violations
When the switch detects an intrusion on a port, it sets an “alert flag” for that
port and makes the intrusion information available as described below. While
the switch can detect additional intrusions for the same port, it does not list
the next chronological intrusion for that port in the Intrusion Log until the
alert flag for that port has been reset.
To Next Page
Loading...
Need help?
General
