10. If an expansion slot cover is installed in the lower slot, remove the slot cover.
CAUTION: You must remove the lower expansion slot cover to avoid damaging the riser card
when removing or installing the card.
Figure 2-32 Removing the Lower Expansion Slot Cover
11. To remove the riser card, disconnect the hood sensor cable from the system board (1), pull back
the arm on the back of the riser card slot (2), then lift the riser card out of the riser card slot (3).
Figure 2-33 Removing the Riser Card
ENWW Replacing the Riser Card 33
To Next Page
Loading...
