MEMORY
Type
Non-ECC, DDR3 SDRAM, 1333 MHz, SODIMM
(
NOTE:
1600 MHz memory may ship on rp7 but the memory will not run at 1600MHz. It will clock down to 1333MHz)
Maximum
16 GB
# of Slots
2
NOTE:
Full availability of 4 GB or more of memory requires a 64-bit operating system. With Windows 32-bit operating
systems, the amount of usable memory is dependent upon your configuration, so that above 3 GB all memory may not be
available due to system resource requirements.
MEMORY UPGRADES
Memory upgrades are accomplished by adding single or multiple DIMMs of the same or varied sizes. This chart does not
represent all possible memory configurations. The HP RP7 Retail System supports non-ECC DDR3 PC3-10600 (1333 MHz) and
PC3-8500 (1066 MHz) memory.
CAUTION:
You must shut down the Retail System and disconnect the power cord before adding or removing memory
modules. Regardless of the power-on state, voltage is always supplied to the memory modules as long as the Retail System
is plugged in to an active AC outlet. Adding or removing memory modules while voltage is present may cause irreparable
damage to the memory modules or system board.
MEMORY CONFIGURATIONS
Slot
1 2
1 GB 1 GB
2 GB 1 GB 1 GB
4 GB 2 GB 2 GB
8 GB 4 GB 4 GB
16 GB
8 GB 8 GB
SOFTWARE
HP Client Management Solutions
(available for free download from
hp.com/go/easydeploy
)
HP SoftPaq Download Manager
HP Client Catalog for Microsoft SMS
HP Systems Software Manager
HP Client Automation Starter
QuickSpecs
HP RP7 Retail System, Model 7800
Standard and Configurable Components
DA - 14350 North America — Version 15 — February 10, 2014
Page 16
To Next Page
Loading...
