8 錯誤! 尚未定義樣式。
2 Physical Installation
2-1 Procedure
Figure 2-1
1. Make sure the WPS and MFP (Multi-Function Peripheral) are powered OFF.
2. Connect the MFP to the USB port on the WPS.
3. Connect the Power Adapter to the WPS Power port, power on the MFP.
4. Power on the WPS.
5. Check the WPS LEDs:
• The Power LED should be ON.
• The 802.11g LED should be ON.
• The Attention LED should be Off.
6. Begin Software installation.
To Next Page
Loading...
