Data rate matching
range
Data access time
(from BOT)
54 to 160 MB/s
47-140 MB/s 40-120 MB/s
62 seconds typical for LTO 4
media
Average load time
<19 seconds (RW)
<22 seconds (WORM
<19 seconds (RW)
<22 seconds (WORM
<19 seconds (RW)
22 seconds (WORM-
initialized) Uninitialized
WORM media can take up to
70 seconds
Average unload
time
<19 seconds (RW)
<22 seconds (WORM-
initialized
<19 seconds (RW)
<22 seconds (WORM-
initialized) Uninitialized
<19 seconds (RW)
22 seconds (WORM-
initialized)
Uninitialized WORM media
can take up to 70 seconds
Maximum Storage
Capacity
Native Capacity
17.7 PB
7.5PB
3.75PB
Compressed
Capacity
75 PB
21.3PB
7.5PB
NOTE:
LTO-6 compressed
data listed above is assuming
2.5:1 compression.
NOTE:
LTO-5 compressed
data listed above is assuming
2:1 compression
NOTE:
LTO-4 compressed
data listed above is assuming
2:1 compression
Bulk load unload
station
528 slots
Maximum number of I/E Slots
NOTE:
Minimum of 24 slot I/E station comes with each library. An additional 24-slot or 72-slot I/E station can be
added to any of the Expansion Modules or High Density Expansion Modules up to a maximum of 528 slots.
Initialization
(cartridge inventory)
time
Less than 3 minutes, fully loaded with labeled cartridges
Cartridge Swap
Time
18 to 20 seconds, consisting of two Move Medium commands
Input
Requirements
Auto-range to domestic and international AC voltages
Nominal / Range
Line Frequency
50 Hz / 60Hz
Range Line Voltage
200 VAC to 240 VAC
Typical Input Current
8A max
Power
Consumption
VA max 1600W (Standard 2N power)
Connectors
FC
LC Connector
Drives Supported
Native Fibre Drives: LTO-6 Ultrium 6650 FC, LTO-5 Ultrium 3280 FC and LTO-4 Ultrium 1840 FC
Maximum Number
of Drives
12 drives in a single frame up to maximum of 96 drives with multiple expansion frames
Acoustic Noise
Sound Power Level
Operating 7.3 Bel
Idle 7.3 Bel
QuickSpecs
HP StoreEver ESL G3 Tape Libraries
Technical Specifications
DA - 14074 Worldwide — Version 16 — November 1, 2013
Page 26